Laura Ashley PXY202 Manual de uso y cuidado

Busca en linea o descarga Manual de uso y cuidado para No Laura Ashley PXY202. Laura Ashley PXY202 Use and Care Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 1
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
Assembly Instructions
Blue Gingham Complete Pendant # PXY202
1. Attach the mounting plate to the outlet box by using two
mounting screws.
2. Thread the cord through "C" spider of the shade, attach
the nipple of the socket to "C" spider and secure it with
the connector.
3. Unscrew two set screws and remove the cord strap.
(See Fig.1)
4. Measure the desired length of the cord (A) from the
canopy to the top end of the connector. Leave additional
8" cord (B) above the canopy, then cut off the unnecessary
cord. (See Fig.2)
5. Mark the 3" cord (C) from the top of the cord. Use a knife
to peel off the insulation of the cord (C) carefully to show
three inside wires out. (See Fig.2)
Caution : Cutting too deep may cut off three inside
wires and destroy the insulation surface of the three
inside wires.
6. Peel off the three wires from the top at about 5/8" length(D)
to expose the copper for wiring.
7. Restore the cord strap and fasten it with the set screws.
(See Fig.1)
8. Pull out the outlet wires and house grounding wire from the
outlet box. Make wire connections using wire nuts:
---The black wire from the fixture to the black wire from the
power source.
---The white wire from the fixture to the white wire from the
power source.
---The green wire from the fixture to the house grounding
wire from the power source.
Carefully put the wires back into the outlet box.
9. Attach the canopy to the mounting plate by aligning the side
holes, then secure it with the screws.
10. Install a bulb (not included). Note relamping label at socket
or packaging area for maximum allowed wattage.
11. Turn on the power at the main fuse or circuit breaker box.
Outlet Box
House Grounding Wire
Wire Nut
Mounting Plate
Mounting Screw
Cord
Black Wire
White Wire
Green Wire
Canopy
B (8")
D (5/8")
C (3")
Fig.2
Fig.1
Cord Strap
Cord
Set Screw
Canopy
Screw
Canopy
"C" Spider
Connector
Shade
Socket
Nipple
Cord
A
Vista de pagina 0
1

Indice de contenidos

Pagina 1 - Assembly Instructions

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUITBREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.NOTE: 1. Before installing, cons

Comentarios a estos manuales

Sin comentarios